![]() The red wire line output from motion sensor goes to the switch 1 input of the dual switch module. Remove the cap connecting all the red wires. Usually, the motion sensor light has the line voltage (black wire) going into the motion sensor and from motion there is a red wire going to power the bulbs. However, you might buy a motion sensor replacement from $15 to $20 (if it's Home Depot's house brand Defiant, it's the same as Heath Zennith) The cheapest one is the Moes House (Tuya) Zigbee Dual Switch Module (not the wall switch) like $13 shipped from Aliexpress (one issue is it might not fit into the same junction box)īut since your said motion sensor wasn't working right, so. I'm using dual switch/relay module to turn traditional motion sensor lights into z-wave or zigbee motion sensor lights. And another rule so that if the switch is ON, the outdoor lights are ON.Īm I on the right track as far as devices, installation, and rules? Is there a better way? This will be my first motion sensor and I don't want any unpleasant surprises. I'll write the rules necessary so that motion (during hours of darkness) will tun the light on for 15 minutes. The motion sensor will be wired "hot" by bypassing the switch and always be powered. ![]() I will connect the line, neutral, and ground as needed, but will not connect anything to the load terminal(s). ![]() My plan is to replace the switch inside the house with a Z-Wave equivalent (probably Zooz). It is installed under an eave, so relatively protected from rain and snow. It doesn't really need to work at these temperatures, just not be damaged by them. I found this HomeSeer Z-Wave Floodlight Sensor and was wondering if anyone had any experience with it and can comment on if it will function during Minnesota winters where the temperature can occasionally get to -20F (-30C). My preference is for a line-voltage powered sensor that has the ability to directly control the attached lights. So I've been looking for a motion sensor and switch I can pair with HE to control these lights. And recently this sensor started flaking out, so now nothing really works. Then repeat as needed or until I get so frustrated I just turn them off and walk away. Then to get back into "motion" mode I have to turn them off for a while, then back on, then hope the motion sensor takes over. If I want to turn the lights on manually, I have to flip the switch on-off a couple times to get them to turn on. If the sensor detects motion, the lights turn on. If the switch is on, the motion sensor is active. If the switch is off, the lights are off. So, I've got three lights on the front of my house that are controlled by a traditional motion sensor and a switch.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |